Microscan MS-Q Imager Bedienungsanleitung PDF herunterladen (Seite 64)

Battery

Installation

See “Batch/Battery Interface” on page 1-7 for instructions on installing the battery.

Charging the Lithium Ion Battery

The battery automatically charges every time a cable interface is attached to the MS-Q

and the host is powered-on.

The RS-232 interface power adapter must be plugged into a wall socket for the

battery to charge.

In USB and PS2 interfaces, the MS-Q and battery draw their current from the host

computer.

Typical Battery Charge Time:

See “USB Battery Charge Mode” on page 6-7 for information about recharging the

battery by use of a USB connection.

Typical Battery Usage when not connected to the host:

• 8 hours Standby

• 4000 Scans

See “Performing a Manual Battery Recharge” on page 6-6 for instructions on

recovering from complete loss of battery charge.

Batch Mode Indicators

(See “MS-Q Indicators” on page 8-5 for additional LED information.)

After a successful decode in Batch Mode, the MS-Q will beep once and the memory LED

will flash either red or amber depending on memory level. Also every 15 seconds the

battery LED will flash green, amber or red depending on the battery level. This is true

whether an Imager is cabled or uncabled.

1. Also consider Microscan’s 2-Bay Battery Charger, P/N 98-000075-xx.

USB and PS2 RS-232 Battery Charger

6 to 8 hours 6 to 8 hours 4 hours

Memory LED Battery LED

a. When power is supplied via cable, the LED will remain green whenever the MS-Q is active.

Sound

Decode and Store

Flash

AMBER or

RED

Flash GREEN,

AMBER or RED

1 Beep

Batch Memory Full Flash

RED

Flash GREEN,

AMBER or RED

3 Beeps

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 203 204

Keine Kommentare

Microscan MS-Q Imager Bedienungsanleitung Seite 64