Microscan MS-Q Imager Bedienungsanleitung PDF herunterladen (Seite 12)

Preliminary Assembly

All MS-Q Handheld Imager configurations include a battery or battery blank, a handle,

and a USB or PS2 cable. Either a battery or a battery blank must be installed for the MS-

Q to operate.

If replacing the battery blank with a battery, see

“Installation Steps for Batch/Battery”

on page 1-7.

When disconnecting the USB or RS-232 cable

from the Imager, do not pull directly on the cable;

grasp and pull on the connector housing to

release the locking mechanism and disengage.

To assemble:

1. Slide the Imager into the handle’s cradle, aligning the ridges

on the inside of the cradle’s parallel lateral stabilizers with

the grooves along the sides of the Imager itself. Be sure that

the handle cradle’s 8-pin mini-DIN connector is inserted

completely into the back of the Imager.

2. If using a cable, plug the cable into the bottom of the handle.

Plug the other end of the cable into the corresponding port

on your host computer.

Grasp here to

remove.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 203 204

Keine Kommentare

Microscan MS-Q Imager Bedienungsanleitung Seite 12