Microscan MS-96 Bedienungsanleitung PDF herunterladen (Seite 49)

MS-9 Scanner User’s Manual 4-1

Read Cycle

Chapter Contents

Read cycles and triggering modes are at the heart of bar code scanning. After you’ve

established communications and completed basic read rate testing, you will need to

address the spatial and timing parameters associated with your application. In a typical

operation a bar coded item moves along a line past a scanner. A sensor or timer acti

vates a read cycle during which the scanner actively searches for bar code symbols. You

will need to decide how to initiate the read cycle and how and when to end it. This sec

tion addresses these issues.

Note: When assigning characters in user-defined fields, the characters NULL <> and ,

can only be entered through embedded menus, not through ESP or serial commands.

Chapter

Read Cycle by ESP .................................................................................4-2

Read Cycle by Serial Command..............................................................4-3

Multisymbol..............................................................................................4-4

Trigger .....................................................................................................4-6

Serial Trigger .........................................................................................4-12

End of Read Cycle.................................................................................4-13

Good Decode Reads .............................................................................4-16

Scanner Setup .......................................................................................4-17

Laser Setup ...........................................................................................4-20

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 225 226

Keine Kommentare

Microscan MS-96 Bedienungsanleitung Seite 49