Microscan MS-4X Bedienungsanleitung PDF herunterladen (Seite 32)

2-4 MS-Connect 210 User’s Manual

Set Network Parameters

You can use ESP to change Ethernet settings. Clicking Send and Save updates the settings

in the MS-Connect 210’s Ethernet module.

Configuring Network Parameters

The following example is based on a default IP address of

169.254.33.228

for the MS-Connect

210 Ethernet module.

1. Determine the host computer’s IP address on the host network.

• Go to the Start menu, select Run, type cmd, and type Enter.

•Type ipconfig at the command prompt.

• Note the IP address of the host computer.

2. At the command prompt, type route add 169.254.33.228 [host computer IP

address] and type Enter. This adds the MS-Connect 210’s IP address to the host

computer’s routing table.

3. At the command prompt, type route print and type Enter.

The command prompt will display a list similar to the following:

The firmware version, MAC

address, and IP address

will automatically populate

the fields shown at left.

Select the appropriate

Subnet Mask, Gateway

address, and TCP port.

Send and Save network parameters.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 67 68

Keine Kommentare

Microscan MS-4X Bedienungsanleitung Seite 32